Silicone Adhesive Bra Pads Solution
The machines needed to make adhesive bra pads, from foam lamination to baking and packing.
Production Process
An adhesive bra pad line runs through seven stages, from laminating the foam to packing the finished pads.
Foam Lamination
Fabric is laminated onto both sides of the foam on a laminating machine.
Fabric Spreading and Cutting
The laminated material is laid on the cutting table by an automatic fabric spreading machine, then cut into pieces of different sizes.
Cup Setting
The cut pieces go onto the cup molding machine, where heat and pressure set them into the cup shape.
Trimming
An automatic swing-arm cutting machine trims the excess material off the set cups.
Machines: SZY-867 swing arm die cutting machine
Glue Injection
The trimmed semi-finished cups go through the glue injection machine, which injects the glue into each cup.
Machines: SZJ-809J glue injection molding machine
Rack Stacking and Tunnel Oven Baking
After injection the cups are stacked on racks. When a 25-layer rack is full, it is pulled to the entrance of the tunnel oven. Baking bonds the silicone glue to the cups.
Machines: MHK-1200-80 tunnel oven
Release Paper and Packing
After the oven, release paper is applied and the finished pads are packed for shipping. Some products need extra steps such as bar tacking and button fixing, depending on the design.
Machines for This Line
Click a machine to see its details and request a quote.
Planning a New Line or an Upgrade?
Tell us your product, target output and factory space. Our engineers will recommend the machines and layout that fit.