Silicone Bra Manufacturing Solution
The machines needed to make silicone bras, from vacuum defoaming to baking and packing.
Production Process
A silicone bra pad line runs through six stages, from bubble-free silicone to finished, packed products.
Vacuum Defoaming
A vacuum defoaming machine removes the air bubbles from the silicone first. The degassed silicone is then poured into bucket A and bucket B of the filling machine.
Machines: XJ series vacuum defoaming machine
Bag Making and Glue Filling
The filling machine heat-presses two rolls of TPU film into a bag. Silicone A and B then pass through a mixing tube into the bag. An acrylic plate presses down from the front to push out the air, and the mould seals the bag. Once the parameters are set, the machine runs fully automatically.
Machines: SZG-260 silicone filling machine
Hot Press Setting
The filled semi-finished pieces go into the silicone setting machine and are shaped by hot pressing in the mould. The usual temperature is about 110 °C, and the time runs from 120 to 380 seconds depending on the product.
Machines: SZD-810P silicone setting machine
Edge Trimming
Set pieces are trimmed with scissors. Round and flower-shaped pieces can be trimmed on the edge cutting machine.
Machines: SZQ-820 edge trimming machine
Glue Brushing
Glue is brushed onto the trimmed pieces by hand. Small nipple covers can also be brushed by machine.
Machines: SZS-205 glue brushing machine
Tunnel Oven Baking and Packing
The brushed pieces pass through the tunnel oven to bake the glue. After baking, release paper is applied and the products are packed for shipping.
Machines: MHK-1200-80 tunnel oven
Machines for This Line
Click a machine to see its details and request a quote.
Planning a New Line or an Upgrade?
Tell us your product, target output and factory space. Our engineers will recommend the machines and layout that fit.